Sunlight-supply Quest PowerDry 4000 Pro Dehumidifier Manuel d'utilisateur télécharger pdf (Page 5)

quest

1-866-933-7486

Quest PowerDry 4000 Pro Installation, Operation and Maintenance Instructions

www.QuestProtect.com

sales@QuestProtect.com

• It must always be used in the upright position.

• The air inlet on top and the front outlet must be at least 1 foot from walls and other obstructions to air

ow.

• If the humid area is very large, dehumidication can be improved by adding an outlet duct to circulate air

to stagnant areas (see Sec. 2.5).

2.3 Electrical Requirements

The Quest PowerDry 4000 Pro can be plugged into a grounded 15 Amp circuit. At 80°F, 60% RH, it draws

10 Amps. Due to the high percentage of a 15 Amp circuit’s capacity that the unit uses, the circuit should be

dedicated to running it only. Amp draw decreases at lower loads and increases at higher loads. At extremely

high loads, a 20 Amp circuit may be required.

If an extension cord is required, it must have a minimum of 12 gauge conductors if 25 feet long or less and

10 gauge conductors if greater than 25 feet long.

2.4 Condensate Removal

The Quest PowerDry 4000 Pro is equipped with an internal condensate pump to remove the water that is

condensed during dehumidication. This allows the condensate to be pumped 30’ with the attached hose.

If the condensate must be pumped more than 20 feet above the unit, a second pump must be added to relay

the condensate.

2.5 Ducting

A detachable rectangular exhaust collar is supplied that will allow 10” round lay-at duct to be attached to

the Quest PowerDry 4000 Pro outlet.

To attach ducting to a collar, put the plastic duct end through the collar center and roll the duct end outward

so that it overlaps the outside of the collar. The duct and collar may then be quickly attached to the Quest

PowerDry 4000 Pro by snapping the collar over the four screws at the blower outlet.

2.6 Power Button

Press the POWER button to turn the dehumidier on or off. When starting the dehumidier the display will

show the accumulated hours. Press the POWER button again to turn the dehumidier off. The display will

also power off.

2.7 Pump Purge Button

During normal operation the pump automatically cycles every four minutes. Press the PURGE button to

remove condensate manually from the reservoir. There are several ways to manually remove water from the

reservoir:

1. Press the PURGE button once and the pump will run for 20 seconds

2. Press and hold the PURGE button and the pump will run for up to 30 seconds

3. Press the PURGE button while the dehumidier is powered off and the pump will run for 30 seconds.

Always manually purge the water reservoir before transport or storage. Turn off the power and allow the

plugged in dehumidier to rest 15 minutes before the nal purge.

1 2 3 4 5 6 7 8 9 10 ... 13 14

Pas de commentaire

Sunlight-supply Quest PowerDry 4000 Pro Dehumidifier Manuel d'utilisateur Page 5